Recently, while writing content about the installation of various add-on modules for the PROA7PLUS, I discovered the “Shutdown system” option. Being familiar with Resideo’s definition of “Shutdown” I sent an email to support to find out exactly what this button does. The answer surprised me.
I was looking for a better way of powering down the panel for the purpose of adding hardware. Having to disconnect the battery and possibly unplug the DC power adapter is inconvenient and unnecessarily difficult. I was hoping for a menu option that would allow me to power down without physically disconnecting anything.
When you enter the menu options of the PROA7PLUS, PROA7, PROA7PLUSC, or PROA7C you see an option for Tools. If you select Tools, you’ll be prompted to enter a code. Once you enter a valid code, and this includes both the Installer Code and the Master Code (4112 and 1234 respectively, by default) you’ll then see a list of additional options.
At the bottom of this list is “Shutdown system”. I was hoping this was an option to power down the system. Just above it in the menu list is “Reboot System” but rebooting doesn’t help when you’re attempting to add or remove hardware. Again, knowing Resideo as I do, I was afraid to simply try out the shutdown option, so I sent an email to their technical support to inquire about what this menu option does. I found the answer a little disturbing.
According to support, when you perform a system shutdown the system cannot be armed. Only 24-Hour emergency zones can be activated, and those alarms are local only because the system’s communicator is also shut down. The burglary portion of the system is useless in this state. Access to the “Tools” menu is also disabled.
You might wonder, as I did, if the communicator is shut down, and the “Tools” menu is disabled how the heck do you recover from this state? According to technical support, it is still possible to send a command to the system from AlarmNet360. This is called a “Resume System” command. This option can only be performed by your alarm dealer.
My takeaways from this are: If your system is not registered with an alarm dealer DO NOT SELECT SHUTDOWN SYSTEM from the “Tools” menu. Doing so will likely cause your system to be permanently inoperable. It’s unclear if an alarm dealer could register a system after the shutdown command has been implemented, and then send the Resume System command. I wouldn’t recommend testing it.
For anyone who may have accidentally hit this menu option and who does have a registered system, contact your alarm dealer immediately. Let them know what happened and that you need to initiate a “Resume System” command through AlarmNet360. They should be able to help you get your system back up and running.
If you’re an Alarm Grid customer who finds yourself in this position you can email us at support@alarmgrid.com, or call 1-888-818-7728. Our support team is here Monday – Friday from 9:00 am – 8:00 pm, with the exception of holidays. We will hopefully be able to send the command to Resume System using AlarmNet360.
